GE PDW7900P Installation Instructions - Page 11
Step 18-connect, Power Supply - review
View all GE PDW7900P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Installation Instructions STEP 18-CONNECT POWER SUPPLY If a power cord with plug is already installed proceed to Step 19. In this step you will need the junction box cover and the #!0 hex heed screw from the screw kit set aside in Step 1. • Secure house wiring to the back of the junction box with a strain relief. • Locate the three dishwasher wires, (white, block and green) with stripped ends. Insert dishwasher wires through the small hole in the junction box bracket, Use UL listed wire nuts of appropriate size to connect incoming ground to green, white to white and block to block. o Install the junction box cover using #10 hex heed screw. Check to be sure that wires ore not pinched under the cover. Junction Box Cover Wires Power Cord ___[__ Ground White, Black and Green "'.'_ Dishwasher Wires Figure BB .... iI / Screw _'/ ..... If house wiring is not 2-wire with ground, a ground must be provided by the installer. When house wiring is aluminum, be sure to use UL Listed anti-oxidant compound and aluminum- to-copper connectors STEP 19-PRETEST CHECK LIST Review this list after installing your dishwasher to avoid charges for a service call that is not covered by your warranty. [] Check to be sure power is OFF. D Open door and remove all foam and paper packaging. [] Locate the Owner's Hanuel set aside in Step 1. [] Read the Owner's Honuol for operating instructions. [] Check door opening and closing. If door does not open and close freely, check for proper routing of spring cable over pulley, tf door drops or closes when released, adjust spring tension. See Step 2, Figure G. [] Checkto be sure that wiring is secure under the dishwasher, not pinched or in contact with door springs or other components. See Step 10. [] Check door alignment with tub, If door hits tub, level dishwasher. See Steps 14 and 15, [] Pull lower rack out, about halfway. Check to be sure it does not roll back or forward on the door. If the rock moves, adjust leveling legs. SeeStep !4. [] Check door alignment with cabineL If clear hits cabinet, reposition dishwasher. See Step !5. [] Check that door spring does not contact water line, fill hose, wiring or other components. See Step !6. [] Verify water supply and drain lines are not kinked or in contact with other components. Contact with motor or dishwasher frame could cause noise. [] Turn on the sink hot water faucet and verify water temperature. Incoming water temperature must be between 120°F and !50°F. A minimum of 120°F temperature is required for best wash performance. See "Prepare Hot Water Line," page S. [3 Add 2 quarts of water to the bottom of the dishwasher to lubricate the pump sea!. [] Turn on water supply_Check for leaks. Tighten connections if needed. [] Remove protective film if present from the control panel and door. !1