GE PDW7900P Installation Instructions - Page 3
Warning
View all GE PDW7900P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Installation Preparation PREPARE DISHWASHER ENCLOSURE This Wall Area must be Free _Pipes or wires 34-1/2"_+ 1//4" Underside of Countertop to Floor 2abinets 24" Hin: Floor MUST Square and Plumb --q be Evenwith Room Floor Plumbing and Electric Service Must Enter Shaded Area Figure A • The rough cabinet opening must be at least 24" deep, 2_" wide and approximotelg 34-1/2" high from floor to underside of the countertop. WARNING To reduce the risk of electric shock, fire, or injurg to persons, the installer must ensure that the dishwasher is completely enclosed at the time of installation, .... (V:: - The dishwasher must be installed so that drain hose is no more than 10' in length for proper drainage. • The dishwasher must be fullg enclosed on the top, sides and back, and must not support and part of the enclosure. I CLEARANCES: When installed into a corner, atlow 2" min. clearance between dishwasher and adjacent cabinet, wall or other appliances. Allow 28_3/8" min. clearance from the fron; of tile dishwasher for door opening. Figure B Figure B Countertop Dti.s.h.w..a.s.h.e.!r F 28-3/8" \ n Copleeanrianngce2"foHr inDiomourm DRAIN REQUIREMENTS a Follow local codes and ordinances. Do not exceed 10' distance to drain. NOTE: Air gap must be used, if waste tee or disposer connection is less than 18" above floor, to prevent siphoning. .... DETERMINE DRAIN METHOD The type of drain installation depends on the following questions. [] Do local codes or ordinances require an air gap? [] Is waste tee tess than 18" above floor? If the answer to either question is YES, Method 1 MUST be used. o If the answers are NO. either method mad be used. CABINET PREPARATION • Drill a t-112" diameter hole in the cabinet wail within the shaded areas shown in Figure A for the drain hose connection. The hole should be smooth with no sharp edges. IMPORTANT: When connecting drain line to disposer, check to be sure that drain plug has been ]==_ 4--- Remove L__.Z--U_ Drain removed. DISHWASHER WILL NOT DRAIN 1FPLUG IS LEFT IN PLACE. _ L__J Plug Figure C .... : Method I - Air Gap with Waste Teeor Disposer An air gap must be usedwhen {eqciiredbg Ioco_codesand ordin0nces.: Theair gap must be installed according to manufacturer's instructions. _ _ Drain Has? Hanger I2 i , _ _ Drain Hose Hanger 3Z' Hir_ Figure D Method Z - Built-in "High Drain Loop" with Waste Tee or Disposer Note: Avoid unnecessary service call charges. Alwags be sure disposer drain plug has been removed before attaching dishwasher drain hose to the disposer,