GE PDW7900P Installation Instructions - Page 8
Ch ck
View all GE PDW7900P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Installation Instructions h_¸ STEP 12-INSTALL SIDE-MOUNT BRACKETS (included with some models) Skip this step if underside of countertop is wood or wood-like materia!, - Install side-mount brackets if underside of countertop is : granite or similar material that will not accept wood screws, , Locate the side mount bracket kit set aside in Step I if it was provided with this model. Otherwise, see Note below. Note: The brackets are available for purchase when needed for models not factory equipped with the side mount kit. Order part GPF65 from gour authorized GE Appliance Dealer. • Fasten the left-hand bracket to the left side of the dishwasher frame. Fasten the right-hand bracket to the right side of the dishwasher frame, using the #8 pan-head screws inctuded with the kit. Refer to Step 15, Figure U for orientation and placement. Side-Mounting Brackets on some models STEP 13-PUSH DISHWASHER INTO FINAL POSITION Tip: Check tub insulation blanket, if equipped. It should be positioned so it is not "bunched up" or interfering with door springs. Check by opening and closing door. o Push dishwasher into the cabinet. The edges of the dishwasher door should be behind the cabinet frame and evenlg atigned with the front face of cabinet doors. Tip: Avoid unnecessurg service charges. Carefullg open and close the door to ensure the door panel is not catching or rubbing on the cabinet frame. STEP 14-LEVEL DISHWASHER IMPORTANT- oishwosmheursbteIevefol rproper dish rack operation and wash performance. • Place level on door and lower rock track as shown. Check to make sure that the dishwasher is Jevet left to right and front to back, Ch ck t°-Ba____ift_ t Figure R ° Level the dishwasher bg adjusting the four leveling legs individuatlg. Refer to Figure S below. • If adjustment to the right rear leveling leg is required, loosen junction bo× bracket screw {through the access hole} and rotate bracket clockwise. Be sure to tighten screw when leveling is completed. Tip: Pull lower rock out, about holfwag. Check to be sure the rack does not roll forward or back into dishwasher. If the rock rolls in either direction, the dishwasher must be leveled again. • If door hits tub, the dishwasher is not installed correctly. Adjust leveling legs to align door to tub. I f J Door Fits and Swings Back Behind Cabinet Frame """ /- \. ,/ ", __ FigureS (_I ' to Adjust ...... J Loosen junctiOn:box ' bracket screw and , rotate bracket outof thewagtoaccessthe " Triigghhttenrearscrleewvelinwghenleg. leveling operation is completed. Correct Alignment Figure Q Alignment 8