GE PDW7900P Installation Instructions - Page 6
It-F,I
View all GE PDW7900P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Installation Instructions STEP 4-REMOVE , Remove the 2 toekick screws and toekick. Set aside for use in Step 21, TOEKICK F,gure I _.,]_ ]ToekickScrews STEP S-INSTALL POWER CORD Skip this step if dishwasher will be direct wired or has a factorg installed power cord. In this step gou will need the junction box cover and the #10 × 1/2" he× head screw from the screw kit set aside in Step 1, The power cord and connections must complg with the National Electrical Code, Section 422 and/or loca! codes and ordinances, Maximum power cord length is 6 feet. Power Cord Kit WX09×70910, available for purchase from an authorized GE Appliance Dealer, meets these requirements. Junction Box Cover Wires Power Cord 0 Dishwasher Wires Figure J • Install strain relief in junction box bracket. ° insert power cord through strain relief and tighten. ° Plokesure block, white and green dishwasher wires ore threaded through small hole in junction box bracket. • Connect power cord white (or ribbed} to dishwasher white wire, black (or smooth) to dishwasher black wire end ground to dishwasher green wire. Use UL listed wire nuts of appropriate size. o Installjunction box cover using #:!0 hex head screw. Be sure wires are not pinched under the cover. STEP 6-INSTALL 90 ° ELBOW • Wrap 90 ° elbow with thread seal tape. o Theod 90 ° elbow into the water valve. o Do not over tighten elbow; water valve bracket could bend or water valve fitting could break. • Position the end of the elbow to face the rear of the dishwasher. 9(7 Elbow Figure K Front of Dishwasher Water _ Valve Bracket ff \ It-F,I I Hose _rhread Seal Tape STEP 7-INSTALL DRAIN HOSE TO DISHWASHER DRAIN PORT Skip this step if drain hose has been pro-installed. In this step gou will need the drain hose and clamp set aside in Step 1, , Stand dishwasher upright. • Place drain hose clamp over Z-3/16" inside diameter end of drain hose, Tip: Prevent drain hose damage and possible leaks. Be careful not to nick or cut the drain hose. , Push the end of the drain hose over the drain pump outlet being careful not to disturb the check valve. Refer to Figure L. o Seat the drain hose end against the hose stops on the pump outlet. • Position hose clamp and tighten clamp. Note: Drain hose against the front lip of the drain hose Pump Outlet \ Hose Stops " supplied with dishwasher is approximatelg 78" long. Ifo longer hose is needed, a 220" long hose (20 feet} mag be purchased from an authorized GE appliance dealer. The !0' long hose is part number _} GPFIOL Figure L 6