Haier UVH13013MTS Use and Care Manual - Page 14
Installation Instructions, PLACEMENT OF THE MOUNTING PLATE, INSTALLATION INSTRUCTIONS
View all Haier UVH13013MTS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
INSTALLATION INSTRUCTIONS Installation Instructions 1. PLACEMENT OF THE MOUNTING PLATE A REMOVING THE KITCHEN HUB™ FROM THE CARTON/REMOVING THE MOUNTING PLATE Remove the packaging CAUTION Wear gloves to protect against sharp edges. 1. Open the box and fold back all four carton flaps fully against the carton sides. Remove the following items from the protective foam: charcoal filters, cord plug, damper, and screws. Do not remove the foam protecting the front of the unit. 2. Carefully roll the unit and carton over onto the top side. The unit should be resting in the foam. 3. Pull the carton up to remove. Carton Foam 4. The mounting plate is attached to the back of the unit. Remove the two screws holding it to the back. The plate will be used as the rear wall template and for mounting the unit to the wall. B FINDING THE WALL STUDS Wall Studs Center 1. Find the studs, using one of the following methods: A. Stud finder OR B. Use a hammer to tap lightly across the mounting surface to find a solid sound. This will indicate a stud location. 2. After locating the stud(s), find the center by probing the wall with a small nail to find the edges of the stud. Then place a mark halfway between the edges. The center of any adjacent studs should be ƎRUƎIURPWKLVPDUN 3. Draw a line down the center of the stud. IMPORTANT: The unit must be installed to at least one wall stud. Screws Mounting Plate 5. Set the unit upright. Remove and properly discard plastic bags and foam. 14 49-2000492 Rev. 2