Haier UVH13013MTS Use and Care Manual - Page 25

INSTALLATION INSTRUCTIONS Installation Instructions C. OUTSIDE BACK EXHAUST (Horizontal Duct) INSTALLATION OVERVIEW C1. Prepare Rear Wall C2. Attach Mounting Plate to Wall C3. Prepare Top Cabinet C4. Adjust Blower Exhaust C5. Assemble and Install Adapter C6. Mount the Kitchen Hub™ C7. Finalize Installation C1 PREPARING THE REAR WALL FOR OUTSIDE BACK EXHAUST You need to cut an opening in the rear wall for outside exhaust. Ŷ5HDGWKHLQVWUXFWLRQVRQWKH5($5:$// TEMPLATE. Ŷ7DSHLWWRWKHUHDUZDOOOLQLQJXSZLWKWKHKROHV previously drilled for holes A and B in the mounting plate. Ŷ&XWWKHRSHQLQJIROORZLQJWKHLQVWUXFWLRQVRIWKH REAR WALL TEMPLATE. C2 ATTACH THE MOUNTING PLATE TO THE WALL C2 ATTACH THE MOUNTING PLATE TO THE WALL (Cont.) 1. Remove the toggle wings from the bolts. 2. Insert the bolts into the mounting plate through the holes designated to go into drywall and reattach the WRJJOHZLQJVWR»ƎRQWRHDFKEROW To use toggle bolts: Mounting Plate Spacing for Toggles More Than Wall Thickness Toggle Wings Toggle Bolt Bolt Wall End 3. Place the mounting plate against the wall and insert the toggle wings into the holes in the wall to mount the plate. NOTE: Before tightening toggle bolts and wood screw, make sure the tabs on the mounting plate touch the bottom of the cabinet when pushed flush against the wall and that the plate is properly centered under the cabinet. CAUTION Be careful to avoid pinching fingers between the back of the mounting plate and the wall. 4. Tighten all bolts. Pull the plate away from the wall to help tighten the bolts. Attach the plate to the wall using toggle bolts. At least one wood screw must be used to attach the plate to a wall stud. 49-2000492 Rev. 2 25