Haier UVH13013MTS Use and Care Manual - Page 22

INSTALLATION INSTRUCTIONS Installation Instructions B. RECIRCULATING (Non-Vented Ductless) INSTALLATION OVERVIEW B1. Attach Mounting Plate to Wall B2. Prepare Top Cabinet B3. Adjust Blower Exhaust B4. Mount the Kitchen Hub™ B5. Filters B6. Finalize Installation B1 ATTACH THE MOUNTING PLATE TO THE WALL B1 ATTACH THE MOUNTING PLATE TO THE WALL (Cont.) CAUTION Be careful to avoid pinching fingers between the back of the mounting plate and the wall. 4. Tighten all bolts. Pull the plate away from the wall to help tighten the bolts. Attach the plate to the wall using toggle bolts. At least one wood screw must be used to attach the plate to a wall stud. 1. Remove the toggle wings from the bolts. 2. Insert the bolts into the mounting plate through the holes designated to go into drywall and UHDWWDFKWKHWRJJOHZLQJVWR»ƎRQWRHDFKEROW To use toggle bolts: Spacing for Toggles More Than Wall Thickness Mounting Plate Toggle Wings Toggle Bolt Wall Bolt End 3. Place the mounting plate against the wall and insert the toggle wings into the holes in the wall to mount the plate. NOTE: Before tightening toggle bolts and wood screw, make sure the tabs on the mounting plate touch the bottom of the cabinet or the horizontal level line when pushed flush against the wall and that the plate is properly centered under the cabinet. 22 B2 USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET You need to drill holes for the top support screws and a hole large enough for the power cord to fit through. Ŷ5HDGWKHLQVWUXFWLRQVRQWKH723&$%,1(7 TEMPLATE. Ŷ7DSHLWXQGHUQHDWKWKHWRSFDELQHW Ŷ'ULOOWKHKROHVIROORZLQJWKHLQVWUXFWLRQVRQWKH TOP CABINET TEMPLATE. CAUTION Wear safety goggles when drilling holes in the cabinet bottom. 49-2000492 Rev. 2