Hayward Pro Logic® Models: PL-PS-4 PL-PS-8 PL-PS-16 PL-PS-16V Installatio - Page 23
Base Station, AQL-CHEM ORP and pH Sensing Kit, PS-16 Expansion Unit - pro logic ps 8
View all Hayward Pro Logic® manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Base Station Plug in the connector from the wireless base station into the "Wireless" connector on the main PCB in the Pro Logic control unit. Base Station (AQL2-BASE-RF) Connector for Base Station Tighten nut Pro Logic Main PCB AQL-CHEM ORP and pH Sensing Kit Plug in the connector from the AQL-CHEM into the "AQL-CHEM" connector on the main PCB in the Pro Logic control unit. Connector for AQL-CHEM PS-16 Expansion Unit Use four conductor cable (typically phone cable) to connect the PS-16 Expansion Unit to the Pro Logic Control Center as shown below. Note that the terminals on both the Pro Logic main unit and the PS-16 Expansion Unit are numbered: Connect 1 to 1, 2 to 2, etc. Refer to diagram below. Connect screw terminals "1" to "1", "2" to "2", etc. PS-16 Expansion Unit 1 2 3 4 Pro Logic Control Center 20