Hayward Pro Logic® Models: PL-PS-4 PL-PS-8 PL-PS-16 PL-PS-16V Installatio - Page 8
Mounting the Equipment - pro logic pro 8
View all Hayward Pro Logic® manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Pool Sizing Formula Gallons (pool size in feet) Rectangular Length x Width x Average Depth x 7.5 Round Diameter x Diameter x Average Depth x 5.9 Oval Length x Width x Average Depth x 6.7 Liters (pool size in meters) Length x Width x Average Depth x 1000 Diameter x Diameter x Average Depth x 785 Length x Width x Average Depth x 893 Type of Salt to Use It is important to use only sodium chloride (NaCl) salt that is greater than 99.0% pure. This can be found at most pool stores in 40-80 lb. bags labeled "for use in swimming pools". Alternatively, use common food quality or water softener salt that is at least 99.0% pure. It is also acceptable to use water conditioning salt pellets, however, it will take longer for them to dissolve. Do not use rock salt, or salt with more than 1% of yellow prussiate of soda, salt with anti-caking additives, or iodized salt. How to Add Salt For new plaster pools, wait 10-14 days before adding salt to allow the plaster to cure. Turn the circulating pump on and add salt directly into the pool. Brush the salt around to speed up the dissolving process-do not allow salt to pile up on the bottom of the pool. Run the filter pump for 24 hours with the suction coming from the main drain (use pool vacuum if there is no main drain) to allow the salt to evenly disperse throughout the pool. The salt display may take 24 hours to respond to the change in salt concentration. Always check stabilizer (cyanuric acid), when checking salt. These levels will most likely decline together. Use the chart below to determine how much stabilizer must be added to raise the level to 80 ppm. POUNDS and (Kg) OF STABILIZER (CYANURIC ACID) NEEDED FOR 80 PPM Gallons and (Liters) of Pool/Spa water Current Stabilizer Level (ppm) 8,000 (30000) 10,000 (37500) 12,000 (45000) 14,000 (52500) 16,000 (60000) 18,000 (67500) 20,000 (75000) 22,000 (82500) 24,000 (90000) 26,000 (97500) 28,000 30,000 32,000 34,000 36,000 38,000 40,000 (105000) (112500)(120000)(127500)(135000) (142500) (150000) 0 ppm 5.3 (3.6) 6.7 (4.3) 8.0 (3.6) 9.4 (4.3) 10.7 (4.9) 12.0 (5.4) 13.4 (6.1) 14.7 (6.7) 16.0 (7.3) 18.7 (8.5) 20.0 (9.1) 21.3 (9.7) 22.7 (10.3) 25.3 (11.5) 26.7 (12.0) 10 ppm 4.7 (3.2) 5.8 (3.7) 7.0 (3.2) 8.2 (3.7) 9.4 (4.3) 10.5 (4.8) 11.7 (5.3) 12.9 (5.9) 14.0 (6.4) 15.2 (6.9) 20 ppm 4.0 (2.7) 6.0 7.0 8.0 9.0 10.0 11.0 12.0 13.0 (2.7) (3.2) (3.6) (2.2) (4.5) (5.0) (5.4) (5.9) 16.4 (7.4) 14.0 (6.4) 17.2 (8.0) 15.0 (6.8) 18.7 (8.5) 16.0 (7.2) 19.8 (9.0) 21.0 (9.5) 18.0 (8.1) 22.2 (10.0) 19.0 (8.6) 23.3 (10.5) 20.0 (9.0) 30 ppm 3.3 (2.3) 4.2 (2.7) 5.0 (2.3) 5.9 (2.7) 6.7 (3.0) 7.5 8.4 (3.4) (3.8) 9.2 (4.2) 10.0 (4.5) 10.8 (4.9) 11.7 (5.2) 12.5 (5.6) 13.3 (6.0) 14.2 (6.3) 15.0 (6.7) 15.8 (7.1) 16.7 (7.5) 40 ppm 2.7 3.3 4.0 (1.8) (2.1) (1.8) 4.7 5.4 (2.1) (2.4) 6.0 6.7 (2.7) (3.0) 7.4 8.0 (3.3) (3.6) 8.7 (3.9) 50 ppm 2.0 (1.4) 2.5 3.0 (1.6) (1.4) 3.5 4.0 (1.6) (1.8) 4.5 5.0 (2.0) (2.3) 5.5 6.0 (2.5) (2.7) 6.5 (2.9) 9.3 10.0 (4.2) (4.5) 7.0 7.5 (3.2) (3.4) 10.7 (4.8) 8.0 8.5 (3.6) (3.9) 12.0 (5.4) 9.0 (4.1) 12.7 (5.7) 9.5 (4.3) 13.3 (6.0) 10.0 (4.5) 60 ppm 1.3 (.91) 1.7 (1.1) 2.0 (.91) 2.3 (1.1) 2.7 (1.2) 3.0 (1.4) 3.3 (1.5) 3.7 4.0 (1.7) (1.8) 4.3 (2.0) 70 ppm 0.7 0.8 1.0 1.2 1.4 1.5 1.7 1.8 2.0 2.2 (.45) (.54) (.45) (.54) (.64) (.68) (.77) (.82) (.91) (1.0) 4.7 5.0 (2.1) (2.3) 2.3 2.5 (1.1) (1.2) 5.3 5.7 (2.4) (2.6) 2.7 2.8 3.0 (1.2) (1.3) (1.3) 6.3 6.7 (2.8) (3.0) 3.2 3.3 (1.4) (1.5) 80 ppm 0.0 0.0 0.0 0.0 0.0 0.0 0.0 0.0 0.0 0.0 0.0 0.0 0.0 0.0 0.0 0.0 0.0 2. Mounting the Equipment Pro Logic Control Center The Pro Logic is contained in a raintight enclosure that is suitable for outdoor mounting. The control must be mounted a minimum of 5 ft. (2 meters) horizontal distance from the pool/spa (or more, if local codes require). The Control Center is designed to mount vertically on a flat surface with the knockouts facing downward. Because the enclosure also acts as a heat sink (disperses heat from inside the box), it is important not to block the four sides of the control. Do not mount the Pro Logic inside a panel or tightly enclosed area. When selecting a location, note that the standard cables supplied with the Turbo Cell, flow switch, temperature sensors, and valve actuators (if applicable) are all 15 ft. (5m) long. 5