Hayward Pro Logic® Models: PL-PS-4 PL-PS-8 PL-PS-16 PL-PS-16V Installatio - Page 32

External Input When enabled, the filter pump will be forced off when the external input is active. Note that freeze protection will have precedence over this feature. NOTE: Heater1 and Heater2 configuration are identical. If Heater2 is enabled then Valve4 will automatically be disabled due to the fact that they use the same output relay and only 1 function can be assigned to that relay. Heater1 Config. + to view/change Push to access heater options Move to previous/next configuration menu Heater1 Disable Toggle between Enabled and Disabled (default) Heater 1 Move to next menu item or previous/next configuration menu if "Heater1" is enabled Heater1 Name Gas Heater Rotates between all available names Move to next menu item if "Heater1" is enabled Heater1 Cooldown Disabled Toggle between Enabled and Disabled (default) Heater 1 Cooldown Move to next menu item if "Heater1" is enabled Heater1 Extend Disabled if "Heater1" is enabled and 2-speed filter pump is selected Allow Low Speed Disabled Toggle between Enabled and Disabled (default) Heater 1 Extend Move to previous/next configuration menu Toggle between Enabled and Disabled (default) Move to next menu item or previous/next configuration menu if "Heater1" is enabled and variable speed filter pump is selected Minimum Speed Select the desired minimum filter pump speed for Heater 1 (Filter Lowest to Highest) 50% Move to next menu item or previous/next configuration menu display for Heater2 if "Heater2" is enabled Toggle between Enabled and Disabled (default) No Move to previous/next configuration menu Heater1 If the heater is "Enabled", the heater relay will turn on when the water temperature is less than the desired temperature setting and the filter pump is running. The desired temperature is in the "Settings Menu". If applicable, the homeowner will be prompted to enter separate "pool" and "spa" settings. Depending on the position of the pool/spa suction valves, the proper temperature setting will be used. Heater Name The Pro Logic allows you to assign any one of a number of names (e.g. "Gas Heater, Heat Pump, etc.) to each of the heater control functions. This will make the Pro Logic much more user friendly to the homeowner when they want to turn various heaters on or off or set temperatures. A sheet of small name labels is included with the Pro Logic main unit and each remote display/keypad so that appropriate pushbuttons can be labeled the same as the name that you have assigned. Heater Cooldown This feature ensures that the heater cools down before water circulation is stopped. When enabled, the Pro Logic will continue to run the filter pump for 5 minutes after the heater turns off. During this period the filter pump LED will flash and also a "Heater Cooldown, X:XX remaining" message will scroll on the display. When the filter pump is running and the heater is on: Pressing the "Filter" button once will cause the heater to turn off, but the filter pump will continue to run for heater cooldown (filter LED flashing and message on display). Pushing the filter button a second time will override the heater cooldown operation and turn the filter pump off. For a Pool/Spa Setup selection of "Pool Only", "Spa Only" or "Pool and Spa-Std", Heater1 and/or Heater2 cooldown affect the filter pump. For "Pool and Spa-Dual", Heater1 is associated with the spa filter and Heater2 with the pool filter. 29