HP 10842 10000 Series Rack Reference Guide - Page 39

Using the Template, mounting rails.

Get HP 10842 PDF manuals and user guides View all HP 10842 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 39 highlights

Installing Components Using the Template Use the template that was shipped with your rack-mountable component to mark the location of the mounting hardware on the mounting rails of the rack. 1. Push back the tabs (marked #) in the top of the template and place them in the correct holes in the mounting rails. 2. Match up the hole pattern indicated on the sides of the template with the hole pattern in the mounting rails. Make sure you begin measuring in the correct place. If a rack component is already installed immediately below the planned position of the new component, place the template on top of the previously installed component and against the front mounting rails. Figure 4-1: Measuring with the template 3. Use the front of the template to mark the attachment points for rack-mounting brackets, rails, components, or cage nuts on the front of the rack. 4. Use the back of the template to mark the attachment points for rack-mounting brackets, rails, components, or cage nuts on the back of the rack. HP 10000 Series Rack Reference Guide 4-5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
Installing Components
HP 10000 Series Rack Reference Guide
4-5
Using the Template
Use the template that was shipped with your rack-mountable component to mark the
location of the mounting hardware on the mounting rails of the rack.
1.
Push back the tabs (marked
★
) in the top of the template and place them in the
correct holes in the mounting rails.
2.
Match up the hole pattern indicated on the sides of the template with the hole
pattern in the mounting rails.
Make sure you begin measuring in the correct place. If a rack component is already
installed immediately below the planned position of the new component, place the
template on top of the previously installed component and against the front
mounting rails.
Figure 4-1:
Measuring with the template
3.
Use the front of the template to mark the attachment points for rack-mounting
brackets, rails, components, or cage nuts on the front of the rack.
4.
Use the back of the template to mark the attachment points for rack-mounting
brackets, rails, components, or cage nuts on the back of the rack.