HP 11-p100 x360 Convertible PC model numbers 11-p100 through p199 Maintenance - Page 35

USB board, Remove the Phillips PM2.0×3.0 screw

Get HP 11-p100 PDF manuals and user guides View all HP 11-p100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 35 highlights

USB board Description USB board (includes cable) Spare part number 755734-001 Before removing the USB board, follow these steps: 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer. 4. Remove the bottom cover (see Bottom cover on page 23). To remove the USB board: 1. Position the bottom cover upside-down. 2. Remove the Phillips PM2.0×3.0 screw (1). 3. Lift up the ribbon cable to detach it from the bottom cover. The cable is held in place with double-sided tape. 4. Lift up the rear of the board and remove the board from the bottom cover (2). Reverse this procedure to install the USB board. Component replacement procedures 27

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
USB board
Description
Spare part number
USB board (includes cable)
755734-001
Before removing the USB board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the bottom cover (see
Bottom cover
on page
23
).
To remove the USB board:
1.
Position the bottom cover upside-down.
2.
Remove the Phillips PM2.0×3.0 screw
(1)
.
3.
Lift up the ribbon cable to detach it from the bottom cover. The cable is held in place with double-sided
tape.
4.
Lift up the rear of the board and remove the board from the bottom cover
(2)
.
Reverse this procedure to install the USB board.
Component replacement procedures
27