HP 2605 HP Color LaserJet 2605/2605dn/2605dtn - Software Technical Reference - Page 185

NOTE To make the Print on Both Sides (Manually) check box available in the document options, enable the Allow Manual Duplexing option on the Device Settings tab in the Properties print-driver tabs. See the Installable Options section of this chapter. If you want to print on both sides manually while using media that is supported by automatic duplexing, you must select and apply the Not Installed setting on the Duplex Unit (for 2-Sided Printing) option on the Device Settings tab. Follow these steps to manually print on both sides. 1. Select the Print on Both Sides (Manually) check box. 2. Click OK. The even-number pages of the document print. 3. When the control panel shows the MANUALLY FEED message, insert the stack of media (on which the even-number pages have been printed) as indicated in the following figure. Windows HP PCL 6 Unidriver features Figure 5-14 Print on Both Sides Instructions When you have completed the steps that appear in the dialog box, the second half of the print job prints on the back side of the stack of media. The driver does not require the program to specifically support odd- and even-page printing, because the driver coordinates this function. Flip Pages Up option Select the Flip Pages Up check box, which is enabled only when Print on Both Sides is selected, to specify the duplex-binding option. By default, the Flip Pages Up check box is not selected. The following table shows the results of selecting this box, depending on the paper orientation that you select on the Finishing tab. ENWW Finishing tab features 161