HP 3390 Service Manual - Page 231
Critical-error message-tables, Error, x Fuser Error, Laser Error, Scanner Error - error 49
View all HP 3390 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 231 highlights
Critical-error message-tables Table 6-2 Critical-error messages Control panel message 49 Error 50.x Fuser Error Description The all-in-one has experienced an internal embedded software error. The all-in-one has experienced an internal hardware error. 51 Laser Error The all-in-one has experienced an internal hardware error. 52 Scanner Error The all-in-one has experienced an internal hardware error. 54.2, 55.1, 59.16, 59.192, 59.4, 59.99 Errors The all-in-one has experienced an internal hardware error. 57 Fan Error 79 Error Turn off then on The all-in-one has experienced a problem with its internal fan. The all-in-one has experienced an internal firmware error. Recommended action Turn off the power by using the power switch, wait at least 30 seconds, and then turn on the power and wait for the all-in-one to initialize. 1. Turn off the power by using the power switch, and then wait at least 30 seconds. 2. If a surge protector is being used, remove it. Plug the all-in-one directly into the electrical outlet. 3. Turn on the power and wait for the all-inone to initialize. Turn off the power by using the power switch, wait at least 30 seconds, and then turn on the power and wait for the all-in-one to initialize. If a surge protector is being used, remove it. Plug the all-in-one directly into the electrical outlet. Use the power switch to turn the all-inone on. Turn off the power by using the power switch, wait at least 30 seconds, and then turn on the power and wait for the all-in-one to initialize. If a surge protector is being used, remove it. Plug the all-in-one directly into the electrical outlet. Use the power switch to turn the all-inone on. Turn off the power by using the power switch, wait at least 30 seconds, and then turn on the power and wait for the all-in-one to initialize. If a surge protector is being used, remove it. Plug the all-in-one directly into the electrical outlet. Use the power switch to turn the all-inone on. Turn off the power by using the power switch, wait at least 30 seconds, and then turn on the power and wait for the all-in-one to initialize. Turn off the power by using the power switch, wait at least 30 seconds, and then turn on the power and wait for the all-in-one to initialize. If you have already installed a memory DIMM in the all-in-one, turn off the all-in-one, remove the memory DIMM, reinstall the DIMM to verify that it is seated properly, and then turn on the all-in-one. If a surge protector is being used, remove it. Plug the all-in-one directly into the electrical ENWW Control-panel messages 209