HP 8/40 Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008 - Page 405
RCS System Messages, RCS-1001
View all HP 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 405 highlights
Chapter RCS System Messages 61 RCS-1001 Message , [RCS-1001], ,, INFO, , RCS has been disabled. Some switches in the fabric do not support this feature. Probable Cause Indicates that the RCS feature has been disabled on the local switch because not all switches in the fabric support RCS or the switch is in nonnative mode. Recommended Action Run the rcsInfoShow command to view RCS capability on the fabric. RCS is supported in Fabric OS v2.6, v3.1 and greater, v4.1 and greater. Run the firmwareDownload command to upgrade the firmware for any switches that do not support RCS. Severity INFO RCS-1002 Message , [RCS-1002], ,, INFO, , RCS has been enabled. Probable Cause Indicates that the RCS feature has been enabled. RCS must be capable on all switches in the fabric to be enabled. If all switches are capable, it is automatically enabled. Recommended No action is required. Action Severity INFO RCS-1003 Message , [RCS-1003], ,, ERROR, , Failed to allocate memory: () Probable Cause Indicates that the specified RCS function failed to allocate memory. Recommended Action This message is usually transitory. Wait a few minutes and retry the command. Check memory usage on the switch using the memShow command. Reboot or power cycle the switch. Severity ERROR Fabric OS Message Reference 353 53-1000600-02