HP 8/40 Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008 - Page 87
Auth-1017, Auth-1018, Auth-1020
View all HP 8/40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
AUTH-1017 3 Probable Cause This may relate to an internal failure. Recommended Copy the message, collect switch information using the supportShow command, and contact your Action switch service provider. Severity ERROR AUTH-1017 Message , [AUTH-1017], ,, ERROR, , Invalid value to start authentication request: port , operation code . Probable Cause Indicates an internal problem with the Secure Fabric OS. Recommended Action Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR AUTH-1018 Message , [AUTH-1018], ,, ERROR, , Invalid value to check protocol type: port . Probable Cause Indicates an internal problem with the Secure Fabric OS. Recommended Action Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command and contact your switch service provider. Severity ERROR AUTH-1020 Message , [AUTH-1020], ,, INFO, , Failed to create timer for authentication: port . Probable Cause Indicates that an authentication message's timer was not created. Recommended Action Usually this problem is transient. The authentication might fail. Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and switchEnable commands. Fabric OS Message Reference 35 53-1000600-02