HP AE370A HP StorageWorks Fabric OS 6.2 administrator guide (5697-0016, May 20 - Page 310
HP StorageWorks B-Series iSCSI Director Blade Configuration
UPC - 882780362611
View all HP AE370A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 310 highlights
Table 74 iSCSI target gateway configuration steps (continued) Step Command Procedure 16 Enable zone configuration. 17 Optional: Enable connection redirection for load balancing. 18 Optional: Configure iSNS client. cfgEnable "cfgname" iscsiSwCfg - -enableconn -s | fosConfig - -enable isnsc isnscCfg - -set /ge -s isnscCfg - -set -m -s "Creating and enabling a zoning configuration" on page 328 "Enabling and disabling connection redirection for load balancing" on page 305 "Enabling the iSNS client service" on page 329 HP StorageWorks B-Series iSCSI Director Blade Configuration This section describes the initial setup required to deploy an iSCSI gateway solution. Install and configure the HP StorageWorks B-Series iSCSI Director Blade in an HP StorageWorks 4/256 SAN Director as described in the Brocade FC4-16IP Hardware Reference Manual before performing these procedures. NOTE: Only the HP StorageWorks 4/256 SAN Director with an iSCSI-enabled HP StorageWorks B-Series iSCSI Director Blade running Fabric OS 5.2.0 or later supports the iSCSI gateway service. NOTE: You can also configure an HP StorageWorks B-Series iSCSI Director Blade through the Web Tools Graphical User Interface as an alternative to the command line interface. See the Web Tools Administrator's Guide for descriptions of GUI-based configuration procedures. HP StorageWorks B-Series iSCSI Director Blade port numbering The HP StorageWorks B-Series iSCSI Director Blade has both GbE ports and FC ports. Ports are addressed using slot number and port number notation-for example, 2/7. FC ports are numbered from 0 through 7; GbE ports are numbered from ge0 through ge7. NOTE: The HP StorageWorks 4/256 SAN Director 16 Port 4Gb Blade does not support FCIP functionality. 308 iSCSI gateway service