HP AE370A HP StorageWorks Fabric OS 6.2 administrator guide (5697-0016, May 20 - Page 466
Creating an IKE and IPsec policy
UPC - 882780362611
View all HP AE370A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 466 highlights
The first step to configuring IPsec is to create a policy for IKE and a policy for IPsec. Once the policies have been created, you assign the policies when creating the FCIP tunnel. IKE negotiates SA parameters and authenticates the peer using the preshared key authentication method. Once the two phases of the negotiation are completed successfully, the actual encrypted data transfer can begin. IPsec policies are managed using the policy command. You can configure up to 32 IKE and 32 IPsec policies. Policies cannot be modified; they must be deleted and re-created in order to change the parameters. You can delete and re-create any policy as long as the policy is not being used by an active FCIP tunnel. Each FCIP tunnel is configured separately and may have the same or different IKE and IPsec policies as any other tunnel. Only one IPsec tunnel can be configured for each GbE port. IPsec parameters When creating policies, the parameters listed in Table 93 are fixed and cannot be modified. Table 93 Fixed policy parameters Parameter Fixed Value IKE negotiation protocol Main mode ESP Tunnel mode IKE negotiation authentication method Preshared key 3DES encryption Key length of 168 bits AES encryption Key length of 128 or 256 The parameters listed inTable 94 can be modified. Table 94 Modifiable policy parameters Parameter Description Encryption Algorithm 3DES-168-bit key AES-128-128-bit key (default) AES-256-256-bit key Authentication Algorithm Security Association lifetime in seconds PFS (Perfect Forward Secrecy) Diffie-Hellman group SHA-1-Secure Hash Algorithm (default) MD5-Message Digest 5 AES-XCBC-Used only for IPsec Security association lifetime in seconds. A new key is renegotiated before seconds expires. seconds must be between 28800 to 250000000 or 0. The default is 28800. Applies only to IKE policies. Choices are On/Off and default is On. Group 1-768 bits (default) Group 14-2048 bits Creating an IKE and IPsec policy For a complete description of the policy command, see the Fabric OS Command Reference. 1. Connect to the switch and log in using an account assigned to the admin role. 2. Enter the policy command to create IKE and IPsec policies: policy --create type number [-enc encryption_method][-auth authentication_algorithm] [-pfs off|on] [-dh DH_group] [-seclife secs] 462 Configuring and monitoring FCIP extension services