HP AE370A HP StorageWorks Fabric OS 6.2 administrator guide (5697-0016, May 20 - Page 64
Verifying host syslog prior to configuring the audit log, Configuring an audit log for specific
UPC - 882780362611
View all HP AE370A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Audit events have the following message format: AUDIT, , [], , , ///,/,, Switch names are logged for switch components and enterprise-class platform names for enterprise-class platform components. For example, an enterprise-class platform name may be FWDL or RAS and a switch component name may be zone, name server, or SNMP. Pushed messages contain the administrative domain of the entity that generated the event. See the Fabric OS Message Reference for details on message formats. For more information on setting up the system error log daemon, see the Fabric OS Troubleshooting and Diagnostics Guide. Audit logging assumes that your syslog is operational and running. Before configuring an audit log, you must perform the following steps to ensure that the host syslog is operational. Verifying host syslog prior to configuring the audit log 1. Set up an external host machine with a system message log daemon running to receive the audit events that will be generated. 2. On the switch where the audit configuration is enabled, enter the syslogdIpAdd command to add the IP address of the host machine so that it can receive the audit events. You can use IPv4, IPv6, or DNS names for the syslogdIpAdd command. 3. Ensure the network is configured with a network connection between the switch and the remote host. 4. Check the host SYSLOG configuration. If all error levels are not configured, you may not see some of the audit messages. Configuring an audit log for specific event classes See the Fabric OS Command Reference for more information about the auditCfg command and command syntax. 1. Connect to the switch from which you wish to generate an audit log and log in using an account assigned to the admin role. 2. Enter the auditCfg --class command, which defines the specific event classes to be filtered. switch:admin> auditcfg --class 2,4 Audit filter is configured. The auditCfg event class operands are identified in Table 4 on page 43. 3. Enter the auditCfg --enable command, which enables audit event logging based on the classes configured in step 2. switch:admin> auditcfg --enable Audit filter is enabled. To disable an audit event configuration, enter the auditCfg --disable command. 4. Enter the auditCfg --show command to view the filter configuration and confirm that the correct event classes are being audited, and the correct filter state appears (enabled or disabled). switch:admin> auditcfg --show Audit filter is enabled. 2-SECURITY 4-FIRMWARE 5. Verify the audit event log setup by making a change affecting an enabled event class and confirming that the remote host machine receives the audit event messages. The following example shows the SYSLOG (system message log) output for audit logging. Oct 10 08:52:06 10.32.220.7 raslogd: AUDIT, 2008/10/10-08:20:19 (GMT), [SEC-3020], INFO, SECURITY, admin/admin/10.32.220.137/telnet/CLI, 64