HP AE370A HP StorageWorks Fabric OS 6.2 administrator guide (5697-0016, May 20 - Page 65
Switch and enterprise-class platform shutdown
UPC - 882780362611
View all HP AE370A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
ad_0/ras007/FID 128, , Event: login, Status: success, Info: Successful login attempt via REMOTE, IP Addr: 10.32.220.137. Oct 10 08:52:23 10.32.220.7 raslogd: 2008/10/10-08:20:36, [CONF-1001], 13, WWN 10:00:00:05:1e:34:02:0c | FID 128, INFO, ras007, configUpload completed successfully. All config parameters are uploaded. Oct 10 09:00:04 10.32.220.7 raslogd: AUDIT, 2008/10/10-08:28:16 (GMT), [SEC-3021], INFO, SECURITY, admin/NONE/10.32.220.137/None/CLI, None/ras007/FID 128, , Event: login, Status: failed, Info: Failed login attempt via REMOTE, IP Addr: 10.32.220.137. Switch and enterprise-class platform shutdown To avoid corrupting your file system, HP recommends that you perform graceful shutdowns of switches and enterprise-class platforms. The following procedure describes how to gracefully shut down an enterprise-class platform. Warm reboots see shutting down the appliance per the instructions below, also known as a graceful shutdown. Cold boots see shutting down the appliance by suddenly shutting down power and then turning it back on, also known as a hard boot. Powering off a switch 1. Connect to the switch and log in using an account assigned to the admin role. 2. Enter the sysShutdown command. 3. At the prompt, enter y. switch:admin> sysshutdown This command will shutdown the operating systems on your switch. You are required to power-cycle the switch in order to restore operation. Are you sure you want to shutdown the switch [y/n]?y 4. Wait until the following message is displayed: Broadcast message from root (ttyS0) Wed Jan 25 16:12:09 2006... The system is going down for system halt NOW !! INIT: Switching to runlevel: 0 INIT: Sending processes the TERM signal Unmounting all filesystems. The system is halted flushing ide devices: hda Power down. 5. Power off the switch. Powering off an enterprise-class platform 1. From the active CP in a dual CP platform, enter the sysShutdown command. When the sysShutdown command is entered on the active CP, the active CP, the standby CP, and any AP blades are all shut down. 2. At the prompt, enter y. Fabric OS 6.2 administrator guide 65