HP BladeSystem bc2000 Command Line Interface Reference Guide HP BladeSystem PC - Page 110
Copying a Configuration File from a Server to the Running Configuration File
View all HP BladeSystem bc2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
Configuration and Image File Commands Command Usage Up to five backup configuration files are supported on the device. The location of a file system dictates the format of the source or destination URL. The entire copying process may take several minutes and differs from protocol to protocol and from network to network. *.prv and *.sys files cannot be copied. Understanding Invalid Combinations of Source and Destination Some invalid combinations of source and destination exist. Specifically, you cannot copy if one of the following conditions exist: The source file and destination file are the same file. n tftp:// is the source file and destination file on the same copy. The following table describes copy characters: Character ! . Description For network transfers, indicates that the copy process is taking place. Each exclamation point indicates successful transfer of ten packets (512 bytes each). For network transfers, indicates that the copy process timed out. Generally, many periods in a row means that the copy process may fail. Copying an Image File from a Server to Flash Memory To copy an image file from a server to flash memory, use the copy source-url image command. Copying a Boot File from a Server to Flash Memory To copy a boot file from a server to flash memory, enter the copy source-url boot command. Copying a Configuration File from a Server to the Running Configuration File To load a configuration file from a network server to the running configuration file of the device, enter the copy source-url running-config command. The commands in the loaded configuration file are added to those in the running configuration file as if the commands were typed in the command-line interface (CLI). Thus, the resulting configuration file is a combination of the previous running configuration and the loaded configuration files with the loaded configuration file taking precedence. Copying a Configuration File from a Server to the Startup Configuration To copy a configuration file from a network server to the startup configuration file of the device, enter copy source-url startup-config. The startup configuration file is replaced by the copied configuration file. Storing the Running or Startup Configuration on a Server Use the copy running-config destination-url command to copy the current configuration file to a network server using TFTP. Use the copy startup-config destination-url command to copy the startup configuration file to a network server. Saving the Running Configuration to the Startup Configuration To copy the running configuration to the startup configuration file, enter the copy running-config startup-config command. 7-2 www.hp.com HP PC Blade Switch CLI Reference Guide