HP BladeSystem bc2000 Command Line Interface Reference Guide HP BladeSystem PC - Page 127
mdix
![]() |
View all HP BladeSystem bc2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
Ethernet Configuration Commands mdix The mdix Interface Configuration (Ethernet) mode command enables cable crossover on a given interface. To disable cable crossover, use the no form of this command. Syntax mdix {on | auto} no mdix Parameters n on - Manual mdix n auto - Automatic mdi/mdix Default Setting n auto for ports 42-46 n on for port 41 n off for ports 1-40 Command Mode Interface Configuration (Ethernet) mode Command Usage Auto: All possibilities to connect a PC with cross or normal cables are supported and are automatically detected. On: It is possible to connect to a PC only with a normal cable and to connect to another device only with a cross cable. No: It is possible to connect to a PC only with a cross cable and to connect to another device only with a normal cable. Example In the following example, automatic crossover is enabled on port e42. Console(config)# interface ethernet e42 Console(config-if)# mdix auto HP PC Blade Switch CLI Reference Guide www.hp.com 8-9
![](/manual_guide/products/hewlettpackard-bladesystem-bc2000-command-line-interface-reference-guide-hp-bladesystem-pc-blade-switch-07763e1/127.png)