HP BladeSystem bc2000 Command Line Interface Reference Guide HP BladeSystem PC - Page 240
qos map policed-dscp
View all HP BladeSystem bc2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 240 highlights
QoS Commands qos map policed-dscp The qos map policed-dscp Global Configuration mode command modifies the policed-DSCP map for remarking purposes. To return to the default map, use the no form of this command. Syntax qos map policed-dscp dscp-list to dscp-mark-down no qos map policed-dscp Parameters n dscp-list - Specifies up to 8 DSCP values separated by a space. (Range: 0-63) n dscp-mark-down - Specifies the DSCP value to mark down. (Range: 0-63) Default Setting The default map is the Null map, which means that each incoming DSCP value is mapped to the same DSCP value. Command Mode Global Configuration mode. Command Usage DSCP values 3,11,19... cannot be remapped to other values. The mapping of the IP DSCP to priority queue is set on a per system basis. If this mode is active, a non-IP packet is always classified to the best effort queue. Example The following command fails to mark down incoming DSCP value 3 as DSCP value 43 on the policed-DSCP map. Console(config)# qos map policed-dscp 3 to 43 Reserved DSCP. DSCP 3 was not configured. 18-24 www.hp.com HP PC Blade Switch CLI Reference Guide