HP BladeSystem bc2000 Command Line Interface Reference Guide HP BladeSystem PC - Page 19
Command Groups, Description
View all HP BladeSystem bc2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Command Line Interface Command Groups The system commands can be broken down into the functional groups shown below. Command Groups Command Group Description 802.1x Commands Specify authentication, authorization and accounting (AAA) methods for use on interfaces running IEEE 802.1x, and enable 802.1x globally. AAA Commands Define the authentication method lists for servers. ACL Commands Display Access Control Lists (ACLs) defined on the device. Address Table Commands Register MAC-layer multicast addresses, and handle MAC-layer secure address to a routed port. Clock Commands Show the configuration or status of the Simple Network Time Protocol (SNTP). Configuration and Image Display the contents of the currently running File Commands configuration file, specify contents of image files. Ethernet Configuration Commands Configure multiple Ethernet type interfaces. GVRP Commands Display the GARP VLAN Registration Protocol (GVRP) configuration information, enable GVRP globally or on an interface. IGMP Snooping Commands Enable the Internet Group Management Protocol (IGMP) snooping. IP Addressing Commands Define a default gateway, set an IP address for interface, delete entries from the host. LACP Commands Configure system or port priority using the Link Aggregation Control Protocol (LACP). Line Commands Display line parameters, enable the command history function, or configure the command history buffer size. Management ACL Commands Define a permit or deny a rule, or configure a management access control list. PHY Diagnostics Commands Display the optical transceiver diagnostics. Port Channel Commands Enter the interface configuration mode to configure a specific, or a multiple port-channel. Port Monitor Commands Start a port monitoring session, or display the port monitoring status. QoS Commands Enable Quality of Service (QoS) on the device, create policy maps, and define traffic classifications Page 2-1 3-1 4-1 5-1 6-1 7-1 8-1 9-1 10-1 11-1 12-1 13-1 14-1 15-1 16-1 17-1 18-1 HP PC Blade Switch CLI Reference Guide www.hp.com 1-7