HP Cisco Catalyst Blade Switch 3020 Cisco Gigabit Ethernet Switch Module for H - Page 15

Open Caveats Because the switch automatically configures the service config global configuration command, it is in the switch startup-config file when you save the running-config file. This command runs every time the switch is restarted, even if a config.text configuration file is in the switch flash memory. The workaround is to prevent these messages from being generated. To do this, enter the switch configuration mode, and issue the no service config command. Save the configuration to flash by using the copy running-config to startup-config command. The preceding error and system messages no longer appear and do not appear when the switch is restarted. • CSCsd86177 When you remove and reconfigure a loopback interface, it does not appear in the ifTable. The workaround is to reload the switch. • CSCse03859 If the switch is in VTP server mode and VLANs with IDs greater than 255 (256 and above) are created, DHCP snooping does not work properly on these VLANs. The workaround is to put the switch in VTP transparent mode before creating the VLANs. • CSCsi70454 The configuration file used for the configuration replacement feature requires the character string end\n at the end of the file. The Windows Notepad text editor does not add the end\n string, and the configuration rollback does not work. These are the workarounds. (You only need to do one of these.) - Do not use a configuration file that is stored by or edited with Windows Notepad. - Manually add the character string end\n to the end of the file. • CSCsj74022 The switch does not correctly update the entPhysicalChildIndex objects from the ENTITY-MIB, and some of the entPhysicalChildIndex entries are missing from the table. This adversely affects network management applications such as CiscoWorks CiscoView because they cannot manage the switch. There is no workaround. Open HP Caveats These are the HP severity 2 open caveats for this release: • rQm 263546 Disconnecting the cable from the console port does not end a Telnet session. If you are in privileged EXEC mode when you remove the cable, the next session that is started on the console port will also be in privileged EXEC mode. The workaround is to end the session before you remove the cable. • rQm 266129 If you power on a switch that does not have a config.txt file (the factory default file) and leave the switch on for few hours, the switch console appears to be stalled during setup. The workaround is to reload the switch before you continue to configure it. Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(44)SE and Later 464831-005 15