HP Cisco Catalyst Blade Switch 3020 Cisco Gigabit Ethernet Switch Module for H - Page 16

Resolved Caveats Open Device Manager Caveats This is the severity 3 device manager caveat for this release: • CSCef94061 If you enter the letter i by itself in the port description, the VLAN status column displays i; this only occurs when you are using Device Manager through Netscape 7.1. The workaround is to run Device Manager through Internet Explorer if you must enter a port description with only the value "i." Resolved Caveats This section describes the caveats that have been resolved in these releases: • "Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(44)SE5" section on page 16 • "Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(44)SE3" section on page 17 • "Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(44)SE2" section on page 17 • "Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(44)SE1" section on page 18 • "Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(44)SE" section on page 21 Cisco IOS Caveats Resolved in Cisco IOS Release 12.2(44)SE5 • CSCsd73245 Excessive IPRT-3-PATHIDX error messages no longer appear in the log file. • CSCsf10850 When configuring an IP SSH version 2 connection, you can no longer create an RSA key that is less than 768 bits. • CSCso63475 A switch now boots correctly after a software reload or power cycle. In previous releases, under some rare circumstances, the image would be truncated to zero bytes and the switch would not boot. • CSCsu10229 The cdpCacheAddress value now appears in a GLOBAL_UNICAST address. • CSCsu40077 The switch now correctly processes ingress traffic when a port is configured with a short 802.1x tx-period timer value (such as dot1x timeout tx-period 3). • CSCsu47056 The username is now properly logged when the remote command privileged EXEC command is used to configure a cluster member. Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(44)SE and Later 16 464831-005