HP Cisco Catalyst Blade Switch 3020 Cisco Gigabit Ethernet Switch Module for H - Page 22

Resolved Caveats • CSCsc26726 Gigabit interfaces 0/23 and 0/24 now link up with another switch when the interface speed is set to an explicit value. In previous releases, these ports would only link up with another switch if the ports on that switch were set to autonegotiate. • CSCsc30733 This error message no longer appears during authentication when a method list is used and one of the methods in the method list is removed: AAA-3-BADMETHODERROR:Cannot process authentication method 218959117 • CSCsd01180 The switch no longer reloads when you use a Kron command scheduler routine to automatically copy configuration data using the Secure Copy Protocol (SCP). (Kron is a Cisco IOS utility for scheduling non-prompting CLI commands to execute at a later time.) • CSCsd78044 When IGMP snooping is enabled and an EtherChannel member interface fails, the switch no longer stops forwarding multicast traffic on the EtherChannel. In previous releases, this occurred when multicast routing was enabled and the EtherChannel interface was a member of a multicast group not directly connected (that is, the multicast group that did not have the C flag set in the show ip mroute privileged EXEC command output). • CSCsd85770 This error message no longer appears when you apply the mls qos trust dscp global configuration command to a port: Master sets trust failed, sets to untrust modetrust type update failed on ifc GigabitEthernetx/x Switch(config-if)#Tcam write failed trust dscp %QOSMGR-4-COMMAND_FAILURE: Execution of slave:HQM_IDBTRUST_CMD command failed on GigabitEthernetx/x • CSCse14774 When a switch is connected to a third-party router through an EtherChannel and the EtherChannel is running in Link Aggregation Control Protocol (LACP) mode, the interfaces in the EtherChannel no longer fail after you enter the switchport trunk native vlan vlan-id interface configuration command to change the native VLAN from VLAN 1 (the default) to a different VLAN ID. • CSCsg21537 When MAC addresses are learned on an EtherChannel port, the addresses are now correctly deleted from the MAC address table. • CSCsg30295 When you configure an IP address on a switch virtual interface (SVI) with DCHP and enable DHCP snooping on the SVI VLAN, the switch SVI can now obtain an IP address. • CSCsg70630 A switch with the Dynamic ARP Inspection feature enabled no longer experiences the issue that triggered the display of buffer sharecount messages under certain patterns of ARP packet traffic. • CSCsh74395 When a VLAN includes multiple MAC addresses, the number of MAC addresses shown in SNMP now matches the output of the show mac-address count vlan vlan-id privileged EXEC command. Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(44)SE and Later 22 464831-005