HP Cisco Catalyst Blade Switch 3020 Cisco Gigabit Ethernet Switch Module for H - Page 23
switchport port-security maximum 1 vlan access, show interfaces, define interface-range
View all HP Cisco Catalyst Blade Switch 3020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Resolved Caveats • CSCsi08513 MAC flap-notification no longer occurs when a switch is running VLAN bridge spanning-tree protocol (STP) and fallback bridging is configured on the VLANs running STP. • CSCsi10584 Multiple Spanning-Tree Protocol (MSTP) convergence time has been improved for Cisco IOS Release 12.2. • CSCsi63999 Changing the spanning tree mode from MSTP to other spanning modes no longer causes tracebacks. • CSCsi77705 Broadcast storm control now works correctly on IEEE 802.1Q trunk ports. • CSCsi78737 The cpmCPURising Threshold traps on the switch are no longer missing the cpmProcExtUtil5SecRev and cpmProcessTimeCreated trap components. Note that although the components were missing from the traps, the PROCESS MIB was still populating the objects. • CSCsj22994 ACLs are now configured correctly when they contain ICMP codes 251 to 255. • CSCsj47067 If you upgrade from Cisco IOS Release 12.2(35)SE1 to Release 12.2(37)SE, a security violation no longer occurs when: - You enter the switchport port-security maximum 1 vlan access interface configuration command. - An IP phone with a PC behind it is connected to an access port with port security. • CSCsj52956 The TxBufferFullDropCount counter no longer increments when the switch is a standalone switch. • CSCsj53001 The Total- output-drops field in the show interfaces privileged EXEC command output now displays accurate ASIC drops. • CSCsj64882 When IGMP snooping is enabled, CGMP interoperability mode now works as it should when the upstream multicast router is set up correctly with PIM and IP CGMP. • CSCsj77933 If you enter a space before a comma in the define interface-range or the interface range global configuration command, the space before the comma is now saved in the switch configuration. • CSCsj87991 A switch configured for Link Layer Discovery Protocol (LLDP) now correctly reports the enabled switch capabilities in the LLDP type, length, and value (TLV) attributes. • CSCsj90406 When VTP pruning is enabled, the switch no longer might experience high CPU usage (greater than 90 percent) for up to 20 minutes after the link comes up simultaneously on multiple trunk ports. Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(44)SE and Later 464831-005 23