HP Cisco Catalyst Blade Switch 3020 Cisco Gigabit Ethernet Switch Module for H - Page 24

Documentation Updates • CSCsk25175 When the switch has VTP pruning and an RSPAN session configured, the RSPAN VLAN traffic is now correctly pruned as set up by the VTP pruning configuration. • CSCsk38083 When UDLD is enabled on a Layer 2 interface, and the native VLAN for the port is not configured as a VLAN on the switch, UDLD no longer puts the port into an error-disabled state. • CSCsk67520 If you enter the hostname global configuration command followed by a hostname that contains illegal characters, for example, one that appears to be an IP address, the switch now displays a warning message, but the specified hostname is configured. • CSCsi85257 A Cisco IP Phone now works correctly when it is connected to a port that is configured with CDP bypass and multidomain authentication (MDA). • CSCsk62010 A switch no longer fails when you enter the show interfaces vlan vlan-id switchport privileged EXEC command. • CSCsl33304 Web authentication no longer stops working when IEEE 802.1X re-authentication is enabled and the re-authentication timer expires. Documentation Updates This section provides updates to the product documentation: • "Update to the Software Configuration Guide" section on page 24 • "System Messages Guide" section on page 25 Update to the Software Configuration Guide This text was updated in the "Using IEEE 802.1x Authentication with Guest VLAN section of the software configuration guide: If the switch is trying to authorize an IEEE 802.1x-capable voice device and the AAA server is unavailable, the authorization attempt fails, but the detection of the EAPOL packet is saved in the EAPOL history. When the AAA server becomes available, the switch authorizes the voice device. However, the switch no longer allows other devices access to the guest VLAN. To prevent this situation, use one of these command sequences: • Enter the dot1x guest-vlan supplicant global configuration command to allow access to the guest VLAN. • Enter the shutdown interface configuration command followed by the no shutdown interface configuration command to restart the port. Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(44)SE and Later 24 464831-005