HP Cisco Catalyst Blade Switch 3020 Cisco Gigabit Ethernet Switch Module for H - Page 5

Installation Notes Step 8 Step 9 (Optional) Ensure that you have IP connectivity to the TFTP server by entering this privileged EXEC command: ping tftp-server-address For more information about assigning an IP address and default gateway to the switch, refer to the software configuration guide for this release. Download the image file from the TFTP server to the switch. If you are installing the same version of software that is currently on the switch, overwrite the current image by entering this privileged EXEC command: archive download-sw /overwrite /reload tftp:[[//location]/directory]/image-name.tar The /overwrite option overwrites the software image in flash memory with the downloaded one. The /reload option reloads the system after downloading the image unless the configuration has been changed and not saved. For //location, specify the IP address of the TFTP server. For /directory/image-name.tar, specify the directory (optional) and the image to download. Directory and image names are case sensitive. This example shows how to download an image from a TFTP server at 198.30.20.19 and to overwrite the image on the switch: Switch# archive download-sw /overwrite tftp://198.30.20.19/cgesm-i6l2-tar.122-25.SE1.tar You also can download the image file from the TFTP server to the switch and keep the current image by replacing the /overwrite option with the /leave-old-sw option. Recovering from a Software Failure For recovery procedures, see the "Troubleshooting" chapter in the Cisco Gigabit Ethernet Switch Module for HP-Blade System p-Class Software Configuration Guide for this release. Installation Notes You can assign IP information to your switch by using these methods: • The Express Setup program, as described in the Cisco Gigabit Ethernet Switch Module for HP-Blade System p-Class Hardware Installation Guide. • The CLI-based setup program, as described in the Cisco Gigabit Ethernet Switch Module for HP-Blade System p-Class Hardware Installation Guide. • The DHCP-based autoconfiguration, as described in the Cisco Gigabit Ethernet Switch Module for HP-Blade System p-Class Software Configuration Guide. • Manually assigning an IP address, as described in the Cisco Gigabit Ethernet Switch Module for HP-Blade System p-Class Software Configuration Guide. Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(44)SE and Later 464831-005 5