HP Contura 400 Compaq Contura 400 Family of Personal Computers Maintenance and - Page 288
ATACARD from the PC Card, Table 5-25. Solving Printer Problems
View all HP Contura 400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 288 highlights
The card is not From MS-DOS: For memory formatted. cards, run MEMCARD to format the card. For hard drive cards and flash mass storage cards, run ATACARD, then run FORMAT. From Windows: Select Computer Setup from the Compaq Control Center, then select MEMCARD or ATACARD from the PC Card option. The card is not Contact Compaq Reseller supported. Support for a list of PC Cards tested successfully in Compaq PC Card platforms. Table 5-25. Solving Printer Problems * Problem Probable Cause Solution(s) Printer does not The device drivers Install the correct printer print. for the application drivers for the application are not installed. to the CONFIG.SYS file. Printer that is set Connect the printer to the up for a network is network. not connected to the network. Printer cable is too Replace the cable. long, unshielded, or defective. Printer is off-line. Paper tray is empty. Fill the paper tray and select Online. Printer prints Correct printer Install the correct printer garbled information. drivers are not driver. installed. Cable is not Connect printer cable connected properly to properly to the computer. computer. Printer cable is too Replace the cable. long, unshielded, or defective. * If you experience problems printing, run a printer self-test to determine if it is a printer-specific problem. Refer to the documentation provided with the printer and the application software.