HP D2D HP StorageWorks HP D2D Backup System rack models service and maintenanc - Page 11

Figure 5 Rear view of the HP D2D4112 G1 1. Power supply cable sockets (two) 2. LAN port 1 (always used for data connection) 3. LAN port 2 4. Management LAN port (Do not use for data)) 5. PCI-e slots (two full and one low profile) 6. VGA port for system console monitor 7. Ports for system console keyboard and mouse NOTE: One full PCIe slot has a SmartArray RAID controller card pre-installed. The other full PCIe slot is used for the FC card. You must install the Tape Attach card (SAS or SCSI) in the low profile slot. Using the ProLiant Guide with HP D2D4004 and 4009 G1 models When using the HP ProLiant DL185 G5 guide, be aware of the following HP D2D-specific information: • The system components are illustrated in the 12HDD server diagram. Two processors are supported - Opteron 2222, part number 451810-001, and Opteron 2384, part number 495643-005. If you need to replace a processor, please refer to the document EH938-90942 Replacing processor in HP D2D400x, which can be found on the Manuals page of the HP web site http://www.hp.com/support/manuals. • The HP D2D has removable hard disks, either 6 or 12. • There is no optical media storage. • The configuration of the system memory is 8 GB (8 x 1 GB DIMMs). The part number for each 1 GB DIMM is 416356-001. • The HP D2D is supplied with an HP Smart Array P400 controller (with 512 MB and BBWC) pre-installed in one of the full-height PCI-e slots. For more information about this card, search on http://www.hp.com/support/manuals. Part numbers are as follows: ◦ P400 card: 441823-001 ◦ 512 MB memory: 405835-001 ◦ BBWC: 398648-001 ◦ BBWC cable assembly: 409125-001 • The FC model has an HP StorageWorks Dual Channel 4Gb PCIe Fibre Channel Host Bus Adapter, part number AE312A HP D2D and HP ProLiant 11