HP D2D HP StorageWorks HP D2D Backup System rack models service and maintenanc - Page 21

Table 3 J27 jumper settings D2D Backup System HP D2D4106/4112 G2: Remove all jumpers HP D2D2502/2504 G2: Jumper should be set on pins 1 and 2 After replacing the motherboard G2 products For all G2 products you must: 1. Install the latest BIOS revision from the relevant product site. All BIOS revisions can be found at http://www.hp.com/support/downloads (under Storage - Disk Storage Systems - Disk to disk Backup - HP D2D Backup Systems). 2. Reboot the system. During the system BIOS boot process, when the prompt to Press F9 is visible, press the F9 key to enter the RBSU (ROM-based Setup Utility) or BIOS Setup. This is so that you can change. 3. Change the Performance options, as shown in the following table. NOTE: Unless noted otherwise, the settings apply to all G2 products. Table 4 RBSU settings RBSU setting Sub-setting Sub-sub-setting Current Change to... Advanced Options Advanced Memory Speed with 1066 MHz Performance Tuning 2 DIMMs per Maximum Options Channel 1333 MHz Maximum Service Options Product Id (ignore M/B default warning displayed) Appropriate Product ID for G2 shown in table below Advanced Options Thermal Configuration (HP D2D4324/4312 only) Optimal Cooling Increased Cooling Power Management HP Power Profile Options Balanced Power and Maximum Performance Performance HP Power Regulator HP Dynamic Power HP Static High Savings Mode Performance Mode 4. Change the BIOS ID, as shown in the following table. Table 5 BIOS IDs for G2 products Model D2D2502i G2 BIOS ID number 596141-B21 After replacing the motherboard 21