HP D2D HP StorageWorks HP D2D Backup System rack models service and maintenanc - Page 17

Replacing the memory module, G1 HP D2D Backup Systems - replace usb

Get HP D2D PDF manuals and user guides View all HP D2D manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

Figure 10 HP D2D2502 and HP D2D2504 G2 Series flash memory module 1 location of the memory module and USB connector 2 screw and bracket securing USB cable connector (not HP D2D4324/4312) 3 cable and connector to the motherboard (not HP D2D4324/4312) Replacing the memory module, G1 HP D2D Backup Systems NOTE: It is normally sufficient to replace the USB stick, leaving the existing cable in place. See the previous section, if you are replacing the memory model in a G2 product. 1. Power off and remove the cover from the HP D2D, as described in the appropriate HP ProLiant Maintenance and Service guide, and locate the memory module (labeled 4 on the diagram). 2. Pull the failed memory module out of the USB connector (1) and simply plug in the replacement module. 3. If you need to replace the cable as well, first unscrew the bracket (2) holding the USB connector and then disconnect the cable from the motherboard (3). Replace the whole cable and tighten the screw on the bracket. Make sure both ends of the cable are connected securely. Replacing the memory module, G1 HP D2D Backup Systems 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
Figure 10 HP D2D2502 and HP D2D2504 G2 Series flash memory module
location of the memory module and USB connector
1
screw and bracket securing USB cable connector (not HP D2D4324/4312)
2
cable and connector to the motherboard (not HP D2D4324/4312)
3
Replacing the memory module, G1 HP D2D Backup Systems
NOTE:
It is normally sufficient to replace the USB stick, leaving the existing cable in place.
See the previous section, if you are replacing the memory model in a G2 product.
1.
Power off and remove the cover from the HP D2D, as described in the appropriate HP ProLiant
Maintenance and Service guide, and locate the memory module (labeled
4
on the diagram).
2.
Pull the failed memory module out of the USB connector (
1
) and simply plug in the replacement
module.
3.
If you need to replace the cable as well, first unscrew the bracket (
2
) holding the USB connector
and then disconnect the cable from the motherboard (
3
). Replace the whole cable and tighten
the screw on the bracket. Make sure both ends of the cable are connected securely.
Replacing the memory module, G1 HP D2D Backup Systems
17