HP Designjet L25500 HP Designjet L25500 Printer Series - User's guide (first e - Page 33

Unload a roll from the take-up reel, Substrate unload, Unload roll

Get HP Designjet L25500 PDF manuals and user guides View all HP Designjet L25500 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

NOTE: If you want to move the printer, first remove the take-up reel sensor and cable housing unit from the foot of the printer stand. Place the sensor and cable housing unit on the printer stand crossbar and use the blue plastic screw to affix the housing unit to the leg of the stand, as shown, while the printer is being moved. When reinstalling the housing unit, make sure that the wheel on the foot of the printer stand is pointing forward. Unload a roll from the take-up reel 1. On the printer's front panel, select the icon, and then select Substrate unload > Unload roll. The printer advances the substrate to allow for cutting. 2. Lift the loading table to its upright position. 3. Switch the wind-direction switch to the Off position. The switch is in the off position when it is centered (in other words, when the switch is neither in position 1 nor position 2). Handle the substrate ENWW Use the take-up reel 29

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
NOTE:
If you want to move the printer, first remove the take-up reel sensor and cable housing unit
from the foot of the printer stand. Place the sensor and cable housing unit on the printer stand crossbar
and use the blue plastic screw to affix the housing unit to the leg of the stand, as shown, while the printer
is being moved. When reinstalling the housing unit, make sure that the wheel on the foot of the printer
stand is pointing forward.
Unload a roll from the take-up reel
1.
On the printer's front panel, select the
icon, and then select
Substrate unload
>
Unload roll
.
The printer advances the substrate to allow for cutting.
2.
Lift the loading table to its upright position.
3.
Switch the wind-direction switch to the Off position. The switch is in the off position when it is
centered (in other words, when the switch is neither in position 1 nor position 2).
ENWW
Use the take-up reel
29
Handle the substrate