HP ENVY 13-d100 Maintenance and Service Guide - Page 53

Heat sink, and then remove the following components

Get HP ENVY 13-d100 PDF manuals and user guides View all HP ENVY 13-d100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 53 highlights

15. Disconnect the RTC battery cable (4) from the system board. 16. Remove the system board. Reverse this procedure to install the system board. Heat sink Description Heat sink (includes replacement thermal material) Spare part number 829314-001 Before removing the heat sink, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the bottom cover (see Bottom cover on page 26), and then remove the following components: a. Battery (see Battery on page 28) b. Solid-state drive (see Solid-state drive on page 29) c. WLAN module (see WLAN module on page 31) d. Power connector bracket (see Power connector cable on page 36) Component replacement procedures 43

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
15.
Disconnect the RTC battery cable
(4)
from the system board.
16.
Remove the system board.
Reverse this procedure to install the system board.
Heat sink
Description
Spare part number
Heat sink (includes replacement thermal material)
829314-001
Before removing the heat sink, follow these steps:
1.
Turn
off
the computer. If you are unsure whether the computer is
off
or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
Bottom cover
on page
26
), and then remove the following components:
a.
Battery (see
Battery
on page
28
)
b.
Solid-state drive (see
Solid-state drive
on page
29
)
c.
WLAN module (see
WLAN module
on page
31
)
d.
Power connector bracket (see
Power connector cable
on page
36
)
Component replacement procedures
43