HP ENVY 13-d100 Maintenance and Service Guide - Page 54

board each time the heat sink is removed. Replacement thermal material is included with the heat sink

Get HP ENVY 13-d100 PDF manuals and user guides View all HP ENVY 13-d100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 54 highlights

e. Fans (see Fan on page 37) f. System board (see System board on page 39) Remove the heat sink: 1. Following the 1, 2, 3 sequence stamped into the heat sink, remove the three Phillips PM2.0×2.4 screws (1) that secure the heat sink to the system board. 2. Remove the heat sink (2). NOTE: Due to the adhesive quality of the thermal material located between the heat sink and the system board components, it may be necessary to move the heat sink from side to side to detach it. NOTE: The thermal material must be thoroughly cleaned from the surfaces of the heat sink and the system board each time the heat sink is removed. Replacement thermal material is included with the heat sink and system board spare part kits. Thermal paste is used on the system board (1) and the section of the heat sink (2) that services it. 44 Chapter 5 Removal and replacement procedures

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
e.
Fans (see
Fan
on page
37
)
f.
System board (see
System board
on page
39
)
Remove the heat sink:
1.
Following the 1, 2, 3 sequence stamped into the heat sink, remove the three Phillips PM2.0×2.4
screws
(1)
that secure the heat sink to the system board.
2.
Remove the heat sink
(2)
.
NOTE:
Due to the adhesive quality of the thermal material located between the heat sink and
the system board components, it may be necessary to move the heat sink from side to side to detach it.
NOTE:
The thermal material must be thoroughly cleaned from the surfaces of the heat sink and the system
board each time the heat sink is removed. Replacement thermal material is included with the heat sink and
system board spare part kits. Thermal paste is used on the system board
(1)
and the section of the heat
sink
(2)
that services it.
44
Chapter 5
Removal and replacement procedures