HP ENVY 15-as100 Maintenance and Service Guide - Page 43
Solid-state drive, Remove the Phillips M2.0×2.7 screw
View all HP ENVY 15-as100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Solid-state drive Description 512-GB, M2, PCIe, NVMe solid-state drive supporting TLC 256-GB, M2, SATA-3 solid-state drive supporting TLC 256-GB, M2, PCIe, NVMe solid-state drive supporting TLC 128-GB, M2, SATA-3 solid-state drive Spare part number 857487-001 857485-001 857486-001 857484-001 Before removing the solid-state drive, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the bottom cover (see Bottom cover on page 28). 5. Disconnect the battery cable from the system board (see Battery on page 31). Remove the solid-state drive: 1. Remove the Phillips M2.0×2.7 screw (1) that secures the solid-state drive to the computer. (The solid- state drive tilts up.) 2. Remove the solid-state drive (2) by pulling the drive away from the slot at an angle. Reverse this procedure to install the solid-state drive. Component replacement procedures 35