HP ENVY Ultrabook 6-1100 HP ENVY Sleekbook 6 and HP ENVY Ultrabook 6 Maintenan - Page 71
Remove the 4 Phillips PM 2.0×3.0 screws securing the heat sink, from the system board.
View all HP ENVY Ultrabook 6-1100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Before removing the fan, follow these steps: 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer. 4. Remove the base enclosure (see Base enclosure on page 43). 5. Disconnect the battery cable (see Battery on page 44), Remove the fan: 1. Turn the computer, with the front toward you. 2. Disconnect the fan cable (1) from the system board. 3. Remove the 4 Phillips PM 2.0×3.0 screws securing the heat sink (2), and the 2 Phillips PM 2.0×3.0 screws securing the fan (3). 4. Remove the fan/heat sink (4). Reverse this procedure to install the fan/heat sink.. Component replacement procedures 63