HP ENVY dv4t-5300 HP Envy dv4 Notebook PC Maintenance and Service Guide - Page 52
The #2 WLAN antenna cable is connected to the WLAN module Aux terminal., Remove the WLAN module
View all HP ENVY dv4t-5300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Remove the WLAN module: 1. Loosen the Phillips M2.5×4.5 captive screw (1) that secures the wireless module compartment cover to the computer. 2. Lift the right side of the wireless module compartment cover (2) until it rests at an angle. 3. Remove the wireless module compartment cover. The wireless module compartment cover is available in the Plastics Kit, spare part number 676652-001. 4. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module. NOTE: The #1 WLAN antenna cable is connected to the WLAN module "Main" terminal. The #2 WLAN antenna cable is connected to the WLAN module "Aux" terminal. 5. Remove the two Phillips M2.0×3.5 screws (2) that secure the WLAN module to the system board. (The WLAN module tilts up.) 44 Chapter 4 Removal and replacement procedures