HP ENVY m7-u100 Maintenance and Service Guide - Page 45
USB board, Remove the Phillips M2.0×4.8 screw
View all HP ENVY m7-u100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
3. Disconnect the power connector cable (3) from the system board. 4. Remove the power connector cable (4). Reverse this procedure to install the power connector cable. USB board Description Spare part number USB board (includes USB board cable, USB board FFC cable, RJ45 jack, and 2 USB ports) 857823-001 NOTE: The USB board cable is also available using spare part number 857837-001. The USB board FFC cable is also available using spare part number 857833-001. Before removing the USB board, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the bottom cover (see Bottom cover on page 24). 5. Disconnect the battery cable from the system board (see Battery on page 26). 6. Remove the hard drive (see Hard drive on page 31). 7. Remove the WLAN module (see WLAN module on page 32). Remove the USB board: 1. Remove the Phillips M2.0×4.8 screw (1) and the Phillips M2.0×3.8 screw (2) that secure the USB board bracket to the keyboard/top cover. Component replacement procedures 37