HP ENVY m7-u100 Maintenance and Service Guide - Page 46
and the Phillips M2.0×4.8 screw, and channel built into the keyboard/top cover.
View all HP ENVY m7-u100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
2. Remove the USB board bracket (3). 3. Release the ZIF connector (1) to which the USB board FFC cable is connected, and then disconnect the USB board FFC cable from the system board. 4. Disconnect the USB board cable (2) from the system board. 5. Release the USB board cable from the routing clips (3) and channel built into the keyboard/top cover. 6. Remove the two Phillips M2.0×3.8 screws (4) and the Phillips M2.0×4.8 screw (5) that secure the USB board to the keyboard/top cover. 38 Chapter 5 Removal and replacement procedures
2.
Remove the USB board bracket
(3)
.
3.
Release the ZIF connector
(1)
to which the USB board FFC cable is connected, and then disconnect
the USB board FFC cable from the system board.
4.
Disconnect the USB board cable
(2)
from the system board.
5.
Release the USB board cable from the routing clips
(3)
and channel built into the keyboard/top cover.
6.
Remove the two Phillips M2.0×3.8 screws
(4)
and the Phillips M2.0×4.8 screw
(5)
that secure the USB
board to the keyboard/top cover.
38
Chapter 5
Removal and replacement procedures