HP EliteBook 1030 Maintenance and Service Guide - Page 40
Remove the Phillips PM2.0×2.0 screw
View all HP EliteBook 1030 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
5. Disconnect the battery cable. Remove the solid-state drive: 1. Remove the Phillips PM2.0×2.0 screw (1) that secures the drive to the system board. 2. Remove the drive (2) by pulling it away from the connector. NOTE: Solid-state drive drives are designed with notches to prevent incorrect insertion. Reverse this procedure to reassemble and install the solid-state drive. 32 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
5.
Disconnect the battery cable.
Remove the solid-state drive:
1.
Remove the Phillips PM2.0×2.0 screw
(1)
that secures the drive to the system board.
2.
Remove the drive
(2)
by pulling it away from the connector.
NOTE:
Solid-state drive drives are designed with notches to prevent incorrect insertion.
Reverse this procedure to reassemble and install the solid-state drive.
32
Chapter 5
Removal and replacement procedures for Authorized Service Provider parts