HP EliteBook G3 EliteBook 820 G3 Notebook PC EliteBook 828 G3 Notebook PC- Mai - Page 43
Pry up on the top near the display hinge of the bottom cover to disengage it from the computer
View all HP EliteBook G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
2. Remove the 11 rubber plugs (1) and the 11 Phillips PM2.5x5.0 screws beneath them (2) from the bottom cover. Be sure to remove the screws in the following order. 3. Remove the SD card blank and the 1 PM2.0×7.0 screw beneath it (3) that secures the bottom cover to the computer. 4. Pry up on the top (near the display hinge) of the bottom cover to disengage it from the computer (4). Reverse the removal procedures to install the bottom cover. NOTE: There are four different sizes of rubber plugs. Be sure that you reinstall them over the correct screws. Component replacement procedures 33
2.
Remove the 11 rubber plugs
(1)
and the 11 Phillips PM2.5x5.0 screws beneath them
(2)
from the
bottom cover.
Be sure to remove the screws in the following order.
3.
Remove the SD card blank and the 1 PM2.0×7.0 screw beneath it
(3)
that secures the bottom cover to
the computer.
4.
Pry up on the top (near the display hinge) of the bottom cover to disengage it from the computer
(4)
.
Reverse the removal procedures to install the bottom cover.
NOTE:
There are four
different
sizes of rubber plugs. Be sure that you reinstall them over the correct screws.
Component replacement procedures
33