HP Evo n1000v Compaq Evo Notebook N1000 Series Software Guides Software Guide - Page 41
Setting SpeedStep Preferences, Using the SpeedStep Window
View all HP Evo n1000v manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Power Setting SpeedStep Preferences SpeedStep settings can be accessed from either the SpeedStep window or the SpeedStep icon. In addition, SpeedStep can be enabled or disabled in Computer Setup. ✎ If the SpeedStep window and icon are not accessible, they may be disabled in Computer Setup. To enable the window and icon (and other settings in the SpeedStep window), see "Using Computer Setup" later in this section. Using the SpeedStep Window To open the SpeedStep window from the desktop, select Start > Settings > Control Panel > Power Management icon > Intel SpeedStep technology tab. Then set your preferences as instructed in the following table. Preference Procedures Assign a performance mode that applies when the notebook is running on battery power. Assign a performance mode that applies when the notebook is running on AC power. Set the notebook to remain in the same performance mode even if the power source changes. Remove the SpeedStep icon from the taskbar. Select a performance mode from the Running on Batteries list, then select OK. Select a performance mode from the Plugged In list, then select OK. Select the same performance modes from the drop-down lists for Running on Batteries and Plugged In, then select OK. 1. Select the check box for Remove Icon from Taskbar. 2. Select OK in the Advanced window. 3. Select OK or Apply in the main SpeedStep window. 2-14 Software Guide