HP Indigo 20000 CA493-00130 Rev - Page 27
IO_SDV_PSS_JOS_REAR, Home profile = 1, Full high = 3, Force Level Calibration
View all HP Indigo 20000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
12. Activate the motor: a. Open the front door. b. Open Systab. c. Load the profiles for the front and rear motors: ● IO_SDV_PSS_JOS_REAR ● IO_SDV_PSS_JOS_FRONT d. Set each input/output separately the value: Home profile = 1. e. Listen to the profile sound. If there is one click, the motor status is good. 13. Check the maximum available gap between the charge roller and the PIP: a. Open the front door. b. Open Systab. c. Load the profiles for the front and rear motors: ● IO_SDV_PSS_JOS_REAR ● IO_SDV_PSS_JOS_FRONT d. Set each input/output separately to the following values: ● Home profile = 1. ● Full high = 3 e. Use a flashlight to check if there is a gap between the charge roller and the PIP. Check along the entire length of the PIP. 14. Replace the following items in the JOS assembly motor: ● Replace the PIP Seam Stepper (PSS) controller. ● Replace the low voltage wiring (PSS - W137 CRE). ● Replace the charge roller housing. Run the Force Level Calibration wizard. Troubleshooting the charge roller leveling failure - mechanical problem 25