HP Indigo 5000 HP DesignJet 5000 Series Printer - Setup Poster - Page 3

Anti-slip pads st524a Carefully lift printer into the upright position. 4. More unpacking st521 Remove the media rolls and spindles from the Shipping Container. st525 Remove the End Packings and the plastic covering from the printer. st526 Tear off and discard the anti-slip material from the wheels. Important: You do not need to lift the printer. st163 Install the two stabilizers onto the rear of the feet as shown. Make sure you install both stabilizers onto the rear of the feet. Install the pins into the two stabilizers and secure with the retaining clips. Side view Adjust the stabilizer feet so that the wheels do not touch the floor. Packing Strap Desiccant Bag st527 Remove the Packing Tape and the Desiccant Bag. st528 Remove the protective covering from the Printer Window. st529 Open the window and remove the Carriage Packing Material. 5. Install the Take-Up Reel Assembly st569 Install the Pocket on the rear of the printer. Install the Take-Up Reel as shown in the following steps. st530 Loosen the four screws shown above. st531 Release the clamp on the left-hand assembly by removing the screw. Page 3