HP Integrity Superdome SX1000 Windows Integrity Management Agents Reference - Page 12
Bad OS MCA checksum Probable Cause: OS has registered a bad OS_MCA vector
View all HP Integrity Superdome SX1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Event ID Event Severity Event Description One of the temperature sensors crossed its upper non-critical threshold. Probable Cause: The temperature inside the server has gone outside the factory specified range for normal operation. You should quit applications and power down the server to protect its hardware from damage. This event may indicate one of the following conditions: a failed fan blocked air vents or poor ventilation around the server open server chassis cover, or missing drive slot covers high temperature in the room where the server resides an unusually hot hardware component located near one of the server's temperature sensors Recommended Action: Find cause of temperature 755 Warning anomaly and fix it. SNMP Trap: hpTemperature - 755 in HPIFP02TRAP.MIB. 756 Error A temperature inside the server went far outside the factory specified range. Probable Cause: The temperature inside the server has gone far outside the factory specified range for normal operation. To avoid permanent damage to your server hardware, go and turn off the server immediately. This event may indicate one of the following conditions: a failed fan blocked air vents or poor ventilation around the server open server chassis cover, or missing drive slot covers high temperature in the room where the server resides an unusually hot hardware component located near one of the server's temperature sensors Recommended Action: Find cause of temperature anomaly and fix it. SNMP Trap: hpTemperature - 756 in HPIFP02TRAP.MIB. The AC voltage to the power supply was lost or is out of range. Probable Cause: The AC voltage was lost, or is the wrong range for the system. Recommended Action: Verify the power supply is plugged in to the proper voltage for the system. SNMP 757 Warning Trap: RedundantPower - 757 in HPIFP02TRAP.MIB. The power supply AC voltage is out of range. Probable Cause: The AC voltage is connected to the power supply, but it is not the voltage range required for the system. Recommended Action: Connect the power supply to the proper voltage range. SNMP 758 Warning Trap: RedundantPower - 758 in HPIFP02TRAP.MIB. 5001 Warning Invalid OS INIT checksum Probable Cause: OS has registered a bad OS_INIT vector or the data has been lost. Recommended Action: Reboot system to allow vector to be re-registered. SNMP Trap: hpevtBadOsInitChecksum - 5001 in HPIFPTRAP.MIB. 5002 Warning Bad OS MCA checksum Probable Cause: OS has registered a bad OS_MCA vector or the data has been lost. Recommended Action: Reboot system to allow vector to be re-registered. SNMP Trap: hpevtBadOsMcaChecksum - 5002 in HPIFPTRAP.MIB. 5003 Warning BMC interface to IPMI failed Probable Cause: BMC firmware has locked up or the BMC is disabled. Recommended Action: Cycle system power and attempt boot again. If error re-occurs contact your HP representative for support. SNMP Trap: hpevtBootBmcFailed - 5003 in HPIFPTRAP.MIB. 5010 Error Boot cell launch EFI failure Probable Cause: The system has failed to launch EFI because of an internal error. Recommended Action: Reboot or update System FW. If problem persists contact your HP representative for support. SNMP Trap: hpevtBootCellLaunchEfiFailure - 5010 in HPIFPTRAP.MIB. 5011 Error Monarch selection failure Probable Cause: An internal error has caused monarch selection to fail. Recommended Action: Reboot. If problem persists contact your HP representative for support. SNMP Trap: hpevtBootCellMonSelFailure - 5011 in HPIFPTRAP.MIB. 5013 Warning CPU monarch collision Probable Cause: Unexpected error has occurred during monarch selection. Recommended Action: Reboot, if problem persists contact your HP representative for support. SNMP Trap: hpevtBootCellMonarchCollision - 5013 in HPIFPTRAP.MIB. 5023 Error Boot cell virtualize EFI failure Probable Cause: An internal error has occurred that prevented EFI from virtualizing. Recommended Action: Reboot, if problem persists contact your HP representative for support. SNMP Trap: hpevtBootCellVirtualizeEfiFailure - 5023 in HPIFPTRAP.MIB. 5025 Error Boot cell virtualize PAL failure Probable Cause: SFW was unable to virtualize PAL. Recommended Action: Reboot, if problem persists contact your HP representative for support. SNMP Trap: hpevtBootCellVirtualizePalFailure - 5025 in HPIFPTRAP.MIB. 12 Management Agents Event Tables