HP Latex R2000 User Guide - Page 65

Substrate edge holders Usage considerations The purpose of the substrate edge holders is to prevent the substrate edges from lifting up and jamming while printing. If you experience this kind of problem while printing, you can try using the edge holders to overcome it. Once the substrate edge holders are installed on the printer, the maximum width of the loaded substrate (rigid or flexible) is as follows: ● HP Latex R2000: 2440 mm (96 in) ● HP Latex R1000: 1545 mm (60.8 in) IMPORTANT: To use substrate of this maximum width, you must raise the left and right alignment bars. IMPORTANT: No more than five substrate edge holders can be placed in the print zone. The maximum thickness of the substrate is 18 mm (0.7 in). HP strongly recommends that you clean the edge holders regularly. Substrate edge holders setup The substrate edge holders are provided already assembled for use with flexible substrates. If you intend to use rigid substrates, you must install the print-zone modules suitable for rigid substrates. See a video of edge holders setup and usage at http://www.hp.com/go/latexRseries/use_edge_holders. ENWW Substrate edge holders 57