HP ML530 ProLiant ML530 Generation 2 Server Setup and Installation Guide - Page 232
Power Cords, on the product's electrical ratings label. The voltage and current rating of the cord
UPC - 720591250669
View all HP ML530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 232 highlights
Regulatory Compliance Notices Power Cords The power cord set included in your server meets the requirements for use in the country where you purchased your server. If you need to use this server in another country, purchase a power cord that is approved for use in that country. The power cord must be rated for the product and for the voltage and current marked on the product's electrical ratings label. The voltage and current rating of the cord should be greater than the voltage and current rating marked on the product. In addition, the diameter of the wire must be a minimum of 1.00 mm² or 18AWG, and the length of the cord must be between 1.8 m (6 feet) and 3.6 m (12 feet). If you have questions about the type of power cord to use, contact an HP authorized service provider. IMPORTANT: Route power cords so that they will not be walked on or pinched by items placed upon or against them. Pay particular attention to the plug, electrical outlet, and the point where the cords exit from the product. HP ProLiant ML530 Generation 2 Server Setup and Installation Guide A-9